Lenze EMF2181IB - Manual (Page 35)

Commissioning
Configuring the communication module
6
l
35 EDSMF2181IB EN 3.0
6.3 Configuring the communication module
Before the Lenze tools can communicate via the communication module it must be
configured accordingly.
To open the system bus configurator, select the following on the Start menu:
Programs
WLenzeWCommunicationWSystem bus configurator.
In contrast to other communication modules, the individual parameters are not to be
found under the "Settings" tab. Instead, one entry in a telephone directory can be made for
each system for which remote maintenance is to be carried out. There also the usual CAN
parameters such as the baud rate, parameter channel, and time−out can be found.
Steps to be taken for configuring the communication module
1. Select the communication module from the list in the system bus configurator.
2. Double−click the corresponding line.
3. If you are starting the telephone directory for the first time, some configurations are
carried out now and entries for all modems configured on the PC are made.
4. Create an entry in the telephone directory that appears now.
5. Enter the parameters required
6. Enter the user name and password:
– Standard user: "Lenze"
– Standard password: "Lenze"
7. Specify the phone number to be called.
I
Tip!
On some extension systems and in some countries, a pause is required during
the dial−up process. Please gather the settings required for this from the
documentation of the extension system and the PC modem.
8. Select the modem to be used.
9. Close the settings dialog