2 parameters relevant for profinet communication, C13000 | ip address, C13001 | subnetwork mask – Lenze E84DGFCR User Manual
Page 74: Parameters relevant for profinet communication, C13000, Ip address), C13001, Codes, Address), Communication manual 8400 motec profinet

Communication manual 8400 motec PROFINET
Parameter reference
Parameters relevant for PROFINET communication
74
L
EDS84DMOTPNET EN 2.0 - 11/2011
13.2
Parameters relevant for PROFINET communication
This chapter lists the PROFINET parameters of the Communication Unit in numerically
ascending order.
C13000
C13001
Note!
PROFINET command "Reset to factory defaults"
If the "Reset to factory defaults" PROFINET command is executed by an IO
supervisor or an I/O controller, the PROFINET-specific parameters will be reset to
their standard values:
•
| IP address
•
| Subnetwork mask
•
| Gateway address
•
| Active IP address
•
| Active subnetwork mask
•
| Active gateway address
•
| Active station name
•
| Suppress signalling diag. mess. upon
•
| Station name
•
| I&M1 system designation
•
| I&M1 installation site
•
| I&M2 installation date
•
| I&M3 additional information
•
| I&M4 signature code
Parameter | Name:
C13000 | IP address
Data type: UNSIGNED_32
Index: 11575
d
= 2D37
h
Setting of the IP address
Setting the IP configuration ( 30)
Setting range
(min. value | unit | max. value)
Lenze setting
0
4294967295 0
;
Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13001 | Subnetwork mask
Data type: UNSIGNED_32
Index: 11574
d
= 2D36
h
Setting of the subnet mask
Setting the IP configuration ( 30)
Setting range
(min. value | unit | max. value)
Lenze setting
0
4294967295 0
;
Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT