Lenze E84DGFCR - Manual (Page 30)

Communication manual 8400 motec PROFINET
Commissioning
Setting the IP configuration
30
L
EDS84DMOTPNET EN 2.0 - 11/2011
6.4 Setting the IP configuration
The IP configuration is required for addressing the Inverter Drive 8400 motec if
communication between the PC/»Engineer« or the IO controller and the controller is to be
effected via PROFINET. For this, an IP address, subnet mask, and gateway address must be
allocated.
If no PROFINET network or no IO controller is available yet, you have the following options
to allocate the IP address, subnet mask, and gateway address for the Communication Unit:
 Settings via the PROFINET configurator of the »Engineer«
( 31)
 Setting via codes in the »Engineer«
( 33)

Note!
• If the IP parameters are assigned by the IO controller via PROFINET or the
PROFINET configurator of the »Engineer«, changes will become effective
immediately and are saved with mains failure protection.
• The assignment of invalid combinations of IP address, subnet mask, and
gateway address can have the consequence that no connection to the
PROFINET can be established.
• In the case of impermissible settings, the red LED BE blinks ( LED status
displays
( 64)
), and the error message PROFINET: Stack init error
[0x01bc6534]
( 72)
is output.