Profinet: internal error [0x01bc6011, Profinet: internal error [0x01bc6100, Profinet: internal error [0x01bc6101 – Lenze E84DGFCR User Manual
Page 70: Profinet: invalid parameter set [0x01bc641f, Profinet: error: lenze setting loaded [0x01bc6420, Profinet: invalid module configuration [0x01bc6430, 0x01bc6011, 0x01bc6100, 0x01bc6101, 0x01bc641f
Communication manual 8400 motec PROFINET
Error messages
Possible causes and remedies
70
L
EDS84DMOTPNET EN 2.0 - 11/2011
PROFINET: Internal error [0x01bc6011]
PROFINET: Internal error [0x01bc6100]
PROFINET: Internal error [0x01bc6101]
PROFINET: Invalid parameter set [0x01bc641f]
PROFINET: Error: Lenze setting loaded [0x01bc6420]
PROFINET: Invalid module configuration [0x01bc6430]
Response (Lenze setting printed in bold)
Setting:
(; Adjustable response)
;
None System fault : Fault Trouble Quick stop by trouble ; Warning locked Warning Information
Cause
Remedy
Device is damaged.
Send device with error description to Lenze.
Response (Lenze setting printed in bold)
Setting:
(; Adjustable response)
;
None System fault : Fault Trouble Quick stop by trouble ; Warning locked Warning Information
Cause
Remedy
Device is damaged.
Send device with error description to Lenze.
Response (Lenze setting printed in bold)
Setting:
(; Adjustable response)
;
None System fault : Fault Trouble Quick stop by trouble ; Warning locked Warning Information
Cause
Remedy
Device is damaged.
Send device with error description to Lenze.
Response (Lenze setting printed in bold)
Setting:
(; Adjustable response)
;
None System fault : Fault Trouble Quick stop by trouble ; Warning locked Warning Information
Cause
Remedy
No active parameter set could be loaded
• Download application again (including module).
• Send device with error description to Lenze.
Response (Lenze setting printed in bold)
Setting: not possible
None System fault : Fault Trouble Quick stop by trouble Warning locked Warning Information
Cause
Remedy
Access to parameter set was not possible.
• Download application again (including module).
• Send device with error description to Lenze.
Response (Lenze setting printed in bold)
Setting:
(; Adjustable response)
;
None System fault : Fault Trouble Quick stop by trouble ; Warning locked Warning Information
Cause
Remedy
A module or submodule does not comply with the
configuration of the Siemens S7 engineering tool.
Check and correct module configuration.