Lenze E84AYCIB - Manual (Page 73)

EDS84AYCIB EN 4.0 - 11/2010
L
73
E84AYCIB communication manual (INTERBUS)
Index
0x01bc8126 62
0x01bc8127 62
0x01bc8131 62
Establishing communication 39
EtherCAT error messages
Causes and remedies 60
External voltage supply 31
F
Fieldbus status displays 56
Firmware compilation date (C13901) 68
Firmware product type (C13900) 68
Firmware version (C13902) 68
G
General data 17
General safety instructions and application notes 12
Get-OD (PMS service) 50
I
IBS-ACTIVE 57
IBS-INIT 57
IBS-READY 57
Identification 14
Identify (PMS service) 51
Initial switch-on 39
Initialising PCP communication 48
Initiate (PMS service) 49
Installation 23
INTERBUS connection 28
INTERBUS identification 17
INTERBUS ring 27
Interfaces 16
,
17
Internal error (error message) 61
Invalid configuration (error message) 62
Invalid initialisation (error message) 62
Invalid module configuration (error message) 62
Invalid parameter set (error message) 61
L
LED status displays 54
Lenze setting loaded (error message) 61
Lost connection to 8400 base device (error message)
60
M
Max. number of data words 17
Max. PDU length 17
Mechanical installation 24
Memory not accessible (error message) 60
Memory read error (error message) 60
Memory write error (error message) 60
Module ID 17
Module status displays 55
Monitoring 53
Monitoring time for Interbus communication failure
(C13881) 66
Mounting for standard devices 0.25 kW and 0.37 kW
24
Mounting for standard devices from 0.55 kW onwards
25
N
Nameplate 14
Network topology 17
,
27
Notes used 11
Number of nodes 17
O
Operating conditions 17
P
Parameter data transfer 48
Parameter data words (PCP) 17
Parameter reference 63
Parameters of the communication module 63
PCP - length (C13892) 67
PDO mapping 41
PMS services 49
Process data length (C13893) 67
Process data transfer 41
Process data words (PD) 17
Processing time 21
Product description 14
Product features 15
PROFINET error messages (short overview) 59
Protection against uncontrolled restart 39
Protection of persons 13
Protective insulation 18
Protocol data 21
Q
Querying the bus status 57
Querying the current bus status 57
R
Reaction on communication failure (C13880) 66
Read (PMS service) 50
Reject (PMS service) 49
Replacing the communication module 26
Residual hazards 13
S
Safety instructions 12
Safety instructions (representation) 11
Setting the baud rate 37
Setting the number of parameter data words (PCP) 36
Setting the number of process data words (PD) 35