Lenze E84AYCIB - Manual (Page 49)

EDS84AYCIB EN 4.0 - 11/2010
L
49
E84AYCIB communication manual (INTERBUS)
Parameter data transfer
Supported PMS services
9.3 Supported PMS services
Parameters are transferred via the PCP channel (PCP = Peripherals Communication
Protocol). This is executed via PMS services.
In the following, only parameters and their contents are given that are returned by the
Lenze controllers. All other transfer parameters of the given PMS services can be obtained
from the corresponding descriptions of the INTERBUS master.
The following PMS services are supported by Lenze controllers:
 Initiate: Establish a connection from the INTERBUS master to the controller
 Abort: Abort connection
 Reject: Reject impermissible PMS service
 Read: Read parameters
 Write: Write parameters
 Get-OD: Read out the object directory
 Identify: Identification of the controller
 Status: Read the status of the controller
9.3.1 Initiate
The "Initiate" PMS service establishes a logic connection between the INTERBUS master
and the communication module.
The controller provides the following parameters:
9.3.2 Abort
The "Abort" PMS service aborts a logic connection between the INTERBUS master and the
communication module.
9.3.3 Reject
The "Reject" PMS service rejects a non-supported PMS service.
Designation Value Description
Profile number 0 No profile is supported.
Password 0 The password function of INTERBUS is not supported.
Access groups 0 There are no access groups.
Access-Protection Supported TRUE Access protection is supported.
Version OD 0 Version of the object directory