JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual User Manual
Jumo delos t
Table of contents
Document Outline
- 1 Introduction
- 2 Device identification
- 3 Electrical connection
- 3.1 Installation notes
- 3.2 Device connection assignment for M 12x1 machine connector
- 3.3 Connection assignment for order code 470
- 3.4 Connection assignment for order code 471
- 3.5 Connection assignment for order code 475, 476 and 477
- 3.6 Connection assignment for RTD temperature probe for basic type 902940/50
- 4 Installation
- 5 Operation
- 6 Commissioning/start-up
- 6.1 Quick introduction
- 6.2 Unlocking the device (enter the code).
- 6.3 Operation cancellation
- 6.4 Setting the unit of the measured value (Uni.T)
- 6.5 Setting the offset (zero point) (Off.T)
- 6.6 Setting the filter time constant (damping) (DamP)
- 6.7 Setting the mains frequency (Freq)
- 6.8 Setting the output signal (S.Type)
- 6.9 Setting the output signal scaling
- 6.10 Setting the error signal of the analog output (S.Err)
- 6.11 Behavior when the scaling range is exceeded
- 6.12 Setting the switching function (B.Fct)
- 6.13 Setting the switching point (B.Sp)
- 6.14 Setting the release point (B.RSp)
- 6.15 Setting the hysteresis (B.HyS)
- 6.16 Setting the switch-on delay time (B.Dly)
- 6.17 Setting the display alignment (D.Dir)
- 6.18 Setting the display unit (D.Uni)
- 6.19 Displaying the software version of the operating unit (SW.Di)
- 6.20 Displaying the software version of the signal unit (SW.Si)
- 7 Setup program
- 8 Overcoming errors and malfunctions
- 9 Supplement