JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual - Manual (Page 40)

5 Operation
40
5.4.5 Display and operation
Parameters Display Setting range
1
1
The standard setting is displayed bold.
Display alignment Std = standard (for standard operation)
turn = turned through 180° (for operation turned
through 180°)
 Chapter 6.17 "Setting the display alignment
(D.Dir)", page 63
Unit of the actual value
display
(only with analog output) Uni.T = Temperature unit (Uni.T)
Proz = % from the scaled range (Sc.Lo and Sc.Hi)
 Chapter 6.18 "Setting the display unit (D.Uni)",
page 64
Software version of the
operating unit
(cannot be edited) Display of the software version of the operating
unit
 Chapter 6.19 "Displaying the software version
of the operating unit (SW.Di)", page 65
Software version of the
signal unit
(cannot be edited) Display of the software version of the signal unit
 Chapter 6.20 "Displaying the software version
of the signal unit (SW.Si)", page 66
Code
(can only be programmed
via the setup program) 0000 to 0072 to 9999
 Chapter 6.2 "Unlocking the device (enter the
code).", page 42