JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual - Manual (Page 45)

45
6 Commissioning/start-up
6.5 Setting the offset (zero point) (Off.T)
6.5.1 Edited offset setting
With this setting, the measured temperature can be increased by an adjustable value.
How to proceed:
Step Activity
1 Unlock the device.
 Chapter 6.2 "Unlocking the device (enter the code).", page 42
2 "Turn" until "Off.T" appears in the bottom line.
3 "Press"
TIP!
"-" means: the offset is negative - the measured temperature is reduced.
The value is entered "digit-by-digit".