JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual - Manual (Page 52)

6 Commissioning/start-up
52
6.9.2 Setting the scaling end value (Sc.Hi)
How to proceed:
TIP!
The output signal can only be scaled on devices with analog output.
Setting range: Measuring range
Factory-setting: Measuring range end
Step Activity
1 Unlock the device.
 Chapter 6.2 "Unlocking the device (enter the code).", page 42
2 "Turn" until "Sc.Hi" appears in the bottom line.
3 "Press"
TIP!
The value is entered "digit-by-digit“!