JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual - Manual (Page 68)

7 Setup program
68
How to proceed:
Step Activity
1 Install the setup program on the notebook/PC.
2 Screw-fit the connection cable (b) to the connector of the device (2).
3 Connect the USB/TTL converter (3) to the connection cable (b) and PC interface cable
(gray) (c).
4 Connect the PC interface cable (gray) (c) to the notebook/PC.
5 Connect the cable box to the rated voltage supply (1) and the connection cable (b) using
the PVC connection cable (a).
TIP!
During installation, the driver for the USB/TTL converter is also installed on the notebook/PC.