JULABO CF41 Cryo-Compact Circulators - Manual (Page 76)

Cleaning / repairing the unit
76
14. Cleaning / repairing the unit
Caution:
Always turn off the unit and disconnect the mains cable from the power source before
cleaning the unit.
Prevent humidity from entering into the circulator.
Service and repair work may be performed only by authorized electricians.
T16A
T16A
ext Pt100
SERIAL
ALARM REG+
E-PROG STAND-BY
OFF
AUS
T16A
T16A
C
To maintain the full cooling performance,
clean the condenser (C) from time to time.
1. Switch off device by pressing the main
power switch and
2. disconnect mains cable from power
source.
3. Remove 2 screws
4. Lift cover upwards.
5. Remove dirt at condenser by suction
cleaning.
6. Close cover and
7. Fix by means of screws.
8. Unit is ready for operation.
Cleaning:
Clean the outside of the unit using a wet cloth and low surface tension water.
The Cryo-Compact Circulator is designed for continuous operation under normal
conditions. Periodic maintenance is not required.
The tank should be filled only with a bath fluid recommended by JULABO. To avoid
contamination, it is essential to change the bath fluid from time to time.
Repairs:
Before asking for a service technician or returning a JULABO instrument for repair,
please contact an authorized JULABO service station.
When returning the unit:
 Clean the unit in order to avoid any harm to the service personnel
 Attach a short fault description.
 When returning a unit, take care of careful and adequate packing.
 JULABO is not responsible for damages that might occur from insufficient packing.
JULABO reserves the right to carry out technical modifications with repairs for
providing improved performance of a unit.