Troubleshooting, Unit does not respond to rs232 commands, No video – Intelix ASW-WP Installation Manual User Manual
Page 23: Pc audio distorted, Unit does not power on, No video from hdbaset output

ASW-WP Installation Guide
Troubleshooting
Unit does not power on
Apply an active video signal; the unit may be in standby mode.
If using a receiver with PoE, verify that the receiver is powered.
If using a receiver without PoE, you must use a 5v power supply (PS-5D-20TL) connected to the
aux power input on the ASW-WP.
Unit does not respond to RS232 commands
Check your cable connection (page 15).
Turn Display Control OFF by sending the RS232 command “
DFG0
No video
Check front panel LEDs to be sure that the unit is powered up and receiving video.
Unplug signal cable, and replug.
PC Audio distorted
Turn volume down on your PC.
No video from HDBaseT output
Verify the link LEDs on the receiver and the back of ASW-WP are lit; if not, check the twisted pair
cable.
23
- DIGI-VGASD2-R (2 pages)
- DIGI-VGA-F (2 pages)
- SKYPLAY-MX-S (26 pages)
- DIGI-HD-XR (4 pages)
- DIGI-HD-COAX2-S (2 pages)
- DL-DVI-S (16 pages)
- DIGI-DVI-F (4 pages)
- S-V1AT (4 pages)
- S-V1AR (4 pages)
- AVO-V2A2-F (2 pages)
- AVO-V1A2-WP-F (2 pages)
- AVO-V1A2-F (2 pages)
- AVO-V1-WP-F (2 pages)
- AVO-V1-PAIR-F (2 pages)
- AVO-V3PT-F (2 pages)
- AVO-V3HD-F (2 pages)
- AVO-V3AD-WP (2 pages)
- AVO-V3AD-WP-F (2 pages)
- AVO-V3AD (2 pages)
- AVO-V3AD-F (2 pages)
- RF-F (2 pages)
- DIGI-HDMI-HR (4 pages)
- DIGI-HD-IR3-WP-S (2 pages)
- DIGI-HD-IR3-S (2 pages)
- FLX-BO4 (32 pages)
- DL-HDE100 (4 pages)
- DL-HD70 (4 pages)
- DIGI-HDE-S (2 pages)
- DIGI-HD70-S (2 pages)
- DIGI-HD60C-S (4 pages)
- ASW-WP Version Log (2 pages)
- ASW-WP Quickstart Guide (2 pages)
- AVO-V3AD-WP110 (4 pages)
- AVO-V1A2-WP110 (4 pages)
- AVO-V2A2-WP-F (2 pages)
- AVO-V2A2-WP (2 pages)
- AVO-VGA2-WP (4 pages)
- AVO-USB (4 pages)
- AVO-USB-C (4 pages)
- AVO-USB-H (4 pages)
- DIGI-USB2 (2 pages)
- AVO-SVA2-WP-F (2 pages)
- AVO-SVA2-WP (2 pages)
- AVO-SVA2-F (2 pages)