Intelix DIGI-HD-IR3-WP-R - Manual

8001 Terrace Ave.
Suite #201
Middleton, WI 53562 Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
DIGI-HD-IR3-WP Installation
Manual
The Intelix DIGI-HD-IR3-WP transmits HDMI and IR up to 300’
over two twisted pair cables. In environments with high
electromagnetic interference (EMI), shielded twisted pair
cable should be used.
Built-in HDshāk® technology provides dynamic HDMI,
EDID/DDC and HDCP mode selection, guaranteeing
performance and image quality. Plus, onboard HDMI
amplification and buffering allows multiple extenders to be
daisy-chained for greater distances.
The DIGI-HD-IR3-WP features electrostatic discharge (ESD)
protection circuitry which safegaurds the HDMI circuit against
static electricity and other destructive stray voltage.
Maximum Recommended Distances
1080p 1080i 720p 576i/p 480i/p
Cat 6a
(shielded)
150’ 300’ 300’ 300’ 300’
Cat 6 110’ 220’ 220’ 220’ 220’
Cat 5e 100’ 200’ 200’ 200’ 200’
The Intelix DIGI-HD-IR3-WP conforms to HDMI and HDCP specifications.
Intelix does not
guarantee
operation with
devices that do
not conform to
these
specifications.
The Intelix DIGI-
HD-IR3-WP
complies with
HDCP standards.
Distances and
picture quality
may be affected by cable grade, cable quality, source and destination
equipment, RF and electrical interference, and cable patches.
Instructions
1. Turn off power and disconnect the
audio/video equipment by following the
manufacturer’s instructions.
2. Adjust DIP switches for desired mode.
3. Connect all Cat5e cables (ensure T568B
straight-thru wiring).
4. Connect all HDMI cables.
5. Connect power supplies.
6. Power on attached audio/video devices.
Compatible Devices
Compatible Receivers: DIGI-HD-IR3-R, DIGI-HD-IR3-WP-R,
*DIGI-HD-IR2-R
Compatible Transmitters: DIGI-HD-IR3-S, DIGI-HD-IR3-WP-S,
*DIGI-HD-IR2-S, DIGI-HD-4X2, DIGI-HD-4X4, DIGI-HD-4X8,
DIGI-HD-8X8,
*when paired with 2-series extenders, bi-directional IR
is not supported; only source-to-display
Important notice:
Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside the
unit. Doing so will void your warranty.
To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination
equipment must be powered off during installation.
Do not connect the extender to a telecommunication outlet
wired to unrelated equipment. Doing so may damage the
unit or any connected equipment. Ensure all connected
twisted pair cabling is straight-through (point-to-point).
Allow proper ventilation to reduce the risk of thermal
failure.