Intelix ASW-WP Installation Manual - Manual (Page 22)

ASW-WP Installation Guide
12. Connect the ASW-WP to an HDBaseT receiver
with an RS232 port (DIGI-HD60C-R) and
power the devices.
13. Connect your PC COM port to the RS232 port
on the HDBaseT receiver. See p. 14 for more
information on RS232 connections.
14. Press the “Program” button, confirm
the action, and wait for the upload to
finish. The unit is now programmed,
and the Display Control feature is
activated. To disable Display Control -
you will need to send the “Display
Control Off” command via a terminal
program.
15. Disconnect the serial cable from your
PC and connect it to the RS232 port on
the display.
16. To program multiple ASW-WP devices, repeat
steps 12-15 for each unit.
22