Setting up the password, Multi-level password protection, User name" and "password – EZWatch Pro 1.1u User Manual

Page 31: Remote user, Protect your system, 10 setting up the password

Using the EZWatch Pro software

Step 4: Click the "Add" button. The camera will be accessed. Also press the ">>" button, all used
video cameras will be authorized.

Step 5: After you finish the inputs, press the "Add" button. Your new remote user will be saved and
shown in the dialog box.

Step 6: You can enable or disable the "Open video camera" and "Close video camera" for the remote
user to control the video cameras.

Delete a remote user:

You can delete the access for the remote user by doing the following steps:

Step 1: Click the "User name" of the remote user. The name will be selected.

Step 2: Press the "Delete" button.

Step 3: You can press the "Exit" button, to close the "Setup remote user" dialog.

Connecting to and from the local site:

With a modem: To connect to and from the local site, a dedicated phone line is required. You also
need a copy of the EZModem application
installed on the remote computer. This is provided with your Setup CD. After doing the
steps shown above, you can dial to
the local site to see the cameras and record from it, if needed. You can later playback
this clips on the remote site. In the
case you can't have a dedicated line, you can share one by enabling/disabling the
"

Stanby

" feature in the EZWatch Pro

software. This will require manual operation of the modem setup on the local site. The
user name and password must
match on both sites for the connection to be stablished.

With a network: To connect to and from the local site, a dedicated IP address is required. You also
need a copy of the EZNetwork application
installed on the remote computer. This is provided with your Setup CD. After doing the
steps shown above, you can connect
to the local site to see the cameras and record from it, if needed. You can later
playback this clips on the remote site. In the
case you don't have a static IP address, you can find out what dynamic IP address you
have assigned, so you can use it to
connect to the local site. If using a firewall, you need to allow traffic through port 1000.
The user name and password must
match on both sites for the connection to be stablished.

5.10

Setting up the password

You can setup the password by doing the following steps: