EZWatch Pro 1.1u User Manual

Page 13

Using the EZWatch Pro software

You can check the EZWatch Pro software by doing the following steps:

1.Your operation system must be Windows 98SE or above.

2. Check the PCI port connections.

3. The PCI or USB port of the BIOS in the computer has to be set on "enabled".

4. Make sure the Device driver is present and enabled. (Please refer to

5. The PCI port of the computer is operational or not.

6. Please check that your VGA card supports the high color (32 bits) and DirectX.

7. Install DirectX from the CD that ships with the system.

B. The EZWatch Pro software is not able to execute after installed, and shows the following error
message:

Please install "Access runtime" software from the CD that come with system and doing the following
steps:

1. Insert the CD-ROM into the drive, the EZWatch Pro installer should come up automatically and list
all the
available software.

Note:

If the EZWatch Pro installer does not start automatically, click "Start", then "Run" and execute

the file
"Setup.exe" on the CD.