ERICO IJS100 Insulated Joint Slotter User Manual
Insulated joint slotter, Ijs100
Recommended Tools:
18V / 20V Cordless Drill (Not Included)
1.
15/16" 6 point socket with drill attachment
2.
15/16" 6 point socket with ratcheting hand tool
3.
7/16" 6 point socket
4.
1/8" hex key
5.
5/32" hex key
6.
3/16" hex key
7.
TECHNICAL SUPPORT:
www.erico.com
IP8240_B
INSTRUCTION SHEET
1 OF 10
INSULATED JOINT SLOTTER
IJS100
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be completely followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
© 2012 ERICO International Corporation.