ERICO CADDY ROD LOCK Channel Nut - Manual

Tighten to
45 ft-lbs[61 N-m]
1 TURN
Pull
Load
Slip
Load
1 2
3
Load Rating
5
Top Up Mounting (See note 1)
Nut side is always the top side
*Load must not exceed capacity of channel.
Not for use with hot dip galvanized hardware/components.
A B
A - SAE ® J429 GRADE 2; ASTM ® A307 GRADE A,B,C; ISO ® 898 GRADE 4.6
B - SAE ® J429 GRADE 5; ASTM ® A449; ISO ® 898 GRADE 8.8
*Arrow on CADDY ® ROD LOCK Channel Nut must always point down.
U.S. Part No.
Europe Article
Number
Rod Size Pull Load Pull Load Slip Load
CRLS37EG N/A 3/8" 750 LBS 1200 LBS 400 LBS
CRLSM8EG 390003 M8 2750 N 5000 N 1750 N
CRLSM10EG 390004 M10 3750 N 6000 N 1750 N
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com CFS411_F
INSTRUCTION SHEET
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 2 © 2009, 2010 ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any 6.
other purpose.
 


ASTM is a registered trademark of American Society for Testing and Materials
ISO is a registered trademark of International Organization for Standardization
SAE is a registered trademark of SAE International