ERICO CADDY SPEED LINK SLK-Keyless Locking Devices - Manual

"D"
0.2 x "D" @ 90
0.5 x "D" @90
"D"
N/LB
SLK2
<90°
<90°
N/LB N/LB
N/LB
↑
↑
N/LB
SLK3
Wire/Hook
SLKxxLxxxx
Wire/Toggle
SLKxxLxxxxT
Wire/Loop
SLKxxLxxxxLP
Integrated Cable
Y-Hooks
SLKxxYHxxxLxxx
Integrated Cable
Y-Toggle
SLKxxYxxxLxxx
CADDY SPEED LINK
Improper Install
CADDY SPEED LINK
Proper Install
® ®
N/LB
↑
↑
↑
↑
↑
↑
↑
1
2
1
2
N/LB
Description Device
LOAD
N LB
1.5mm wire rope SLK2 196 44
2mm wire rope SLK2 445 100
3mm wire rope SLK3 890 200
TECHNICAL SUPPORT:
www.erico.com CFS464_B
INSTRUCTION SHEET
1 OF 2
© 2012, 2014 ERICO International
Corporation.
CADDY SPEED LINK SLK
SLK Keyless Locking Devices
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment. 5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any 6.
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
®