ERICO CADWELD Exothermic Welding - Manual (Page 35)

The CADWELD
®
PLUS ONE SHOT Process
Fig. 1
Always wear protective safety glasses and gloves
while working with CADWELD ® exothermic products.
Fig. 2
Prepare the proper materials and equipment for the
type of connection you are making. The CADWELD ®
PLUS ONE SHOT system requires a CADWELD ®
ONE SHOT ceramic mold, CADWELD ® PLUS
welding material, wire brush for cleaning/preparing
conductors, control unit, and propane torch.
NOTE: Additional materials may be required for your
specific application. Refer to your mold instructions.
Fig. 3
Check to ensure the ceramic mold is not worn or
broken, which could cause leakage of molten weld
metal during the reaction.
Inspect the CADWELD PLUS ONE SHOT box label to
ensure that it corresponds to the application, indicated
by the:
1. CADWELD PLUS ONE SHOT part number
2. conductor size
3. welding material required
4. other materials required
The mold must be correct for the conductor size and
application. DO NOT MODIFY MOLDS.
33