ElmoMC SimplIQ Digital Servo Drives-Guitar Evaluation Board User Guide - Manual (Page 25)

Whistle, Bell Guitar Evaluation Board User Guide Combined Evaluation Board
MAN-EVLBRD-WHI-BEL-GUI (Ver. 1.401)
25
.9.4 Bell Connections on the Evaluation Board
The Bell is connected to the Evaluation Board by 2mm pitch header connectors (0.51 mm SQ).
Upon assembly, the Bell’s J1, J21 and Power pins as well the Guitar’s J2, J10 and Power pins
should be pressed directly into their respective sockets. Great care should be taken with
alignment to avoid bending the pins.
Note: All the connectors below are internal connectors.
PE
M1
M2
M3
VPW
VLW
PR
J21
J1
M4
Internal
connectors
Internal
connectors