ElmoMC SimplIQ Digital Servo Drives-Guitar Evaluation Board User Guide - Manual (Page 8)

Whistle, Bell Guitar Evaluation Board User Guide Safety Information
MAN-EVLBRD-WHI-BEL-GUI (Ver. 1.401)
8
.1 Warnings
To avoid electric arcing and hazards to personnel and electrical contacts,
never connect/disconnect the servo drive while the power source is on.
Power cables can carry a high voltage, even when the motor is not in
motion. Disconnect the Evaluation Board from all voltage sources before
it is opened for servicing.
The Evaluation Board contains grounding conduits for electric current
protection. Any disruption to these conduits may cause the instrument
to become hot (live) and dangerous.
After shutting off the power and removing the power source from your
equipment, wait at least 1 minute before touching or disconnecting parts
of the equipment that are normally loaded with electrical charges (such
as capacitors or contacts). Measuring the electrical contact points with a
meter, before touching the equipment, is recommended.
.2 Cautions
The Evaluation Board contains hot surfaces and electrically-charged
components during operation.
The maximum DC power supply connected to the instrument must
comply with the parameters outlined in this guide. Furthermore, the
power supply must be isolated from hazardous live voltages using
reinforced or double insulation in accordance to approved safety
standards.
When connecting the Evaluation Board to an approved 12 ~ 195V DC
auxiliary power supply, connect it through a line that is isolated from
hazardous live voltages using reinforced or double insulation in
accordance with approved safety standards.
Before switching on the Evaluation Board, verify that all safety
precautions have been observed and that the installation procedures in
this manual have been followed.