Despatch Protocol Plus Controller (Heat Only) - Manual (Page 25)

Protocol Plus Owner’s Manual O PERATION
Version 2 25
Copyright © 2010 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
To activate Auto Start:
1. On
Auto Start page, set Enable to Yes .
2. LCD displays Active , current date and time
To deactivate Auto Start, on
Auto Start page, set Enable to No .
Once Auto Start is activated, continue to use all operating modes as you normally would.
If an operating mode is running at the time of a preset Auto Start function (provided Auto
Start is activated), the existing operating mode will override the Auto Start function and
the Auto Start will not turn on.
O
All processes set to run in Auto Start must be at least one
minute long for all Run Modes (Manual, Timer, and Profile).
5.6. Setup Mode
Use Setup to configure a number of control parameters. To access Setup, the controller
must read
Stop .
5.6.1. Enter and Exit Setup Mode
Enter Setup from Stop by:
1. Press
Select until Setup displays.
2. Press Page . Security displays.
3. Press Menu . Password displays. Use
▲ or ▼ to enter the proper password and press
Page .
O
Passwords Protection
The controller has two levels of password protected security.
Level one provides access only to those menu pages enabled on
the Enable page. Level two provides access to all menu pages,
including the Enable page. The default security password values
are 1 for level one and 2 for level two.
If an improper password has been entered, the control will
remain at Security. To enter the proper password, press Menu.