DATOptic RM12-S6.TB - Rackmount - Manual (Page 3)

ARCHTTP PROXY SERVER INSTALLATION
112
• Mail (alert by Mail) Configuration:
To enable the controller to send the email function, you need to
configure the SMTP function on the ArcHttp software. To enable
the RAID controller email sending function, click on the “Mail Con-
figuration” link. The "SMTP Server Configurations" menu will show
as following:
When you open the mail configuration page, you will see the
following settings:
(1). SMTP Server Configuration:
SMTP Server IP Address: Enter the SMTP server IP address which is
not McRAID storage manager IP.
Ex: 192.168.0.2.
(2). Mail Address Configurations:
Sender Name: Enter the sender name that will be shown on the
outgoing mail.
Ex: RaidController_1.
Mail address: Enter the sender email that will be shown on the
outgoing mail, but don’t type IP to replace domain name.
Ex: [email protected].
Account: Enter the valid account if your SMTP mail server requires
authentication.
Password: Enter the valid password if your SMTP mail server
requires authentication.