DATOptic RM12-S6.TB - Rackmount - Manual (Page 26)

135
WEB BROWSER-BASED CONFIGURATION
Note:
Please make sure of the inconsistency source generated
by parity error or bad block before you click the recovery
method. Otherwise, you will lose the recovery data.
6.6.7 Stop Volume Set Check
Use this option to stop the “Check Volume Set” function.
6.7 Physical Drive
Choose this option to select a physical disk from the main menu
and then perform the operations listed below.
6.7.1 Create Pass-Through Disk
To create pass-through disk, move the mouse cursor to the main
menu and click on the “Create Pass-Through” link. The relative
setting function screen appears. A pass-through disk is not con-
trolled by the 6Gb/s SATA RAID controller firmware; it can’t be a
part of a volume set. The disk is available to the operating system