BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool - Manual (Page 21)

Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
21
XIT6000-CA
3/8” Tie-Lok ® Tool
Trouble Shooting
Matrix
Symptom Probable cause Recommended Fix Page
Control Module air
pressure valve is in "off"
position. Rotate Control Module valve to open position.
Verify gauges read air pressure. 6
Pinched coil hose line Loosen fitting on coiled hose assembly where it
enters tool body. 5
Kinked or pinched air line Remove right side handle and inspect air lines.
Remove and replace as required.
29
Tension piston
interference with hanger
screw holes. Loosen Hanger Screw on top of tool. Thread
engagement cannot exceed .125 in. 10
Control Module air
pressure valve is in "off"
position. Rotate Control Module valve to open position.
Verify gauges read air pressure. 6
Clamp tail inside tool Remove clamp tail, if jammed remove
maintenance/flip cover and remove clamp
material. 15,18
Knife is in forward
position. Remove or replace knife. Verify missing and or
damaged linkage. 22,26
Wrong clamp type for Verify proper tool for selected clamp. 9
Handle will not
adjust
Handle nut is
damaged/misaligned. Remove handle assembly and inspect
nut/housing for damage. Replace as required. 10
Tool will not
operate when
trigger is
depressed
Clamp will not
insert into tool
* = for additional assistance, contact BAND-IT