beautypg.com

BAND-IT C07569 Bantam Hand Tool User Manual

BAND-IT Tools

background image

Operating
Instructions

C07569

Bantam Hand Tool




Pistol Grip Position:

Tension Release
Levers

Winding Knob

(Also Hammer Surface)

Ratchet Handle

Handle in Pistol Grip
Position

Cutter Handle

Straight Position

Angle Position

Handle Locking Pin

Winding Mandrel

Nose of Tool

1. With the Bantam Tool in the Pistol Grip
Position, place the band in the tool with
sufficient band in the winding mandrel.

2. With ratcheting action, tension the band until
clamp is tight. If necessary, band may be
repositioned by releasing tension with levers.

3. Roll tool over as far as tool will go, and push
forward cutter handle. Remove tool and tap
down ears of clip to complete clamp. Remove
excess material from winding mandrel.

Straight or Angle Position:

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P36287 Rev. C

© Copyright

BAND-IT-IDEX, Inc. 2009

All rights reserved

www.BAND-IT-IDEX.com

Page 1 of 3

1. With the Bantam Tool in the Straight
Position, place the band in the tool with
sufficient band in the winding mandrel.

2. With ratcheting action, tension the band until
clamp is tight.

3. Roll tool over as far as tool will go, and push
forward cutter handle. Remove tool and tap
down ears of clip to complete clamp.