beautypg.com

BAND-IT Ball-Lok Installation User Manual

Band-lok ties, Installation instructions

background image

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P98187 rev. B

© Copyright

BAND-IT-IDEX, Inc. 2006

All rights reserved

www.BAND-IT-IDEX.com

Page 1 of 1

BAND-LOK Ties

Installation
Instructions

Warning:
Always wear safety glasses when assembling and tensioning ties.






















2. Wrap tie around object. Insert
tail end of tie through slot at
opposite end.

3. With needle nose pliers
pull tie to desired tension.

1. Bend tail back over the hood.

4. Using tin snips cut tail end
so that approximately 1/4”
extends out from the hood.

6. Tap the tail and hood down

lightly for a lower profile.

For consistent automatic tensioning of multiple ties, use the A95079 hand tool. This
tool will insure consistency by automatically cutting off after a desired tension in
reached.


Refer to website for warranty information:

http://www.band-it-idex.com/warranty.html

5. With needle nose pliers tuck tail end
under the hood (bend hood up slightly
if necessary).