beautypg.com

BAND-IT S03869 Center Punch Tool User Manual

Operating manual

background image

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # PO6788 rev. D

© Copyright

BAND-IT-IDEX, Inc. 2006

All rights reserved

www.BAND-IT-IDEX.com

Page 1 of 2

S03869 - BAND-IT
Center Punch Tool

Operating
Manual




























1.

Tool is designed specifically for 3/8” and 5/8”

center punch clamps only. Insert clamp in tool and
then insert wrench assembly. If you prefer, install
wrench assembly before clamp is inserted. Slot must
be aligned with clamp tail.

2.

Start “pumping” ratchet wrench forward until proper

tension has been applied.

3.

Place punch on clamp and while holding

tension with ratchet wrench, lock clamp by striking
punch once or more with hammer, depending on
object being clamped.

4.

While holding tension with wrench, pivot tool up

against buckle, then backward several times to
break off clamp tail.

5.

To loosen clamp tail, wind ratchet wrench until

tail is free. Remove ratchet wrench assembly and
clamp tail. Caution: Clamp tail may spring back
once released from tool nose.