BAND-IT K50289 Ball-Lok/Self-Lok Tool - Manual

Tension Adjustment Knob
Tension Indicator
Window
Handle
Warning:
Always wear safety glasses when operating hand tool.
Instructions:
Tool is designed to accept .180" and 1.
.310" wide coated and uncoated ties.
Turn tension adjustment knob until 2.
desired tension setting is displayed in
tension indicator window. Space
between the numbers counts as one-half
setting. See step 7.
Extend handle open to release gripping 3.
mechanism and insert clamp tail into
tool through side load entry.
Squeeze handle repeatedly to tighten 4.
band around object. Be sure to release
handle completely to use full pull-up
stroke of tool. Buckle must be secure
against the tool head. Once the preset
tension has been reached, the handle
will no longer release completely.
To cut off excess clamp tail, squeeze 5.
handle one last time.
The tool must be reset by extending the 6.
handle out until it snaps into place. The
tool will now be ready to apply the next
clamp.
Tension Setting Range: 7.
.180" (4.6mm) Self-Lok 1 - 4 1/2
.180" (4.6mm) Ball-Lok 1 - 4 1/2
.310" (7.9mm) Ball-Lok 1 - 6 1/2
K50289
Ball-Lok / Self-Lok Tool
www. BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # K50250 rev. D
Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
Page 1 of 5
Operating
Instructions