BAND-IT J00169 JR. Tool Adapter - Manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P06287 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 2
J00169 JR.
Tool Adapter
Operating
Instructions
NOTE: USE OF VISE IS OPTIONAL
FOR BAND WIDTHS OF ½” OR
LESS. WE STRONGLY SUGGEST
SECURING THE TOOL IN A VISE
FOR CLAMPS WIDER THAN ½”.
Place BAND-IT tool in vise. BAND-IT JR Adapter installs
over nose of tool. Insert BAND-IT Junior or Junior SID
Clamp in Tool and grip end of band by Band Gripper Lever
contained in the slide block assembly of BAND-IT tool.
Install clamp over hose assembly. Tension clamp by
turning the handle of BAND-IT Tool clockwise. To feel
movement of band, place finger on BAND-IT BAND at
buckle edge (shown by arrow) while tensioning with tool
handle. When you no longer feel band moving through
buckle, MAXIMUM PRESSURE HAS BEEN EXERTED BY
BAND-IT BAND.
A. Roll hose over approximately 30
°,
BACKING OFF TENSION HANDLE ½ to 1
turn only through course of rollover,
depending on type and size of hose.
B. Grip buckle with hook in nose by pushing
cutter handle. Push cutter handle farther to
cut the band completing BAND-IT JR. Clamp.
To Install a BAND-IT Junior Clamp:
1
3
2
The finished BAND-IT JR. Smooth I.D. Clamp.
Lip lock will be bent upward 90° and have a
cut-off edge (shown in green) that is flush to
the edge of the buckle. Edges shown in red
are too high or too low and may result in lower
lock strength or sharp edges.
B
4
CORRECT