BAND-IT IT1000-AB 1/4 Tie-Lok Tool - Manual (Page 5)

Document # I17791 Rev H
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
5 of 38
IT1000-AB
1/4” Tie-Lok ® Tool
Inlet Air Supply
Quick Disconnect
Use one of two
quick-disconnects
supplied or remove
and use 1/4” NPT
fitting
Air Shut-Off Valve
Air Filter Environment:
Standard Filters/Regulators
incorporate polycarbonate bowls and/or
observation windows. DO NOT use in
an environment that will expose the
above mentioned components to
synthetic fluids, organic solvents,
chemicals, cutting lubricants, thread
lock solutions or similar materials.
Tension Pressure
Regulator
Pull Regulator
Knob and twist to
adjust tension,
push to lock
Cut-off Pressure
Regulator
Factory set to 105 PSI
(725 kPa)
Do not adjust
Note: Air Controller Module
must be mounted and operated
in a horizontal position.
Exhaust
Muffler
Filter
Mounting Bracket
Unit may be mounted
on wall or bench
Air Controller Module
Tension
Pressure Gauge
Cut-off
Pressure
Gauge
Cut-off
Outlet
Tension
Outlet
Fluid Drain
Release
Valve
Air System