BAND-IT IT1000-AB 1/4 Tie-Lok Tool - Manual (Page 4)

Document # I17791 Rev H
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
4 of 38
IT1000-AB
1/4” Tie-Lok ® Tool
Air System
The IT1000 is a pneumatic tool that needs a clean and dry air supply. The BAND-IT Air
Controller Module includes a filter to meet these requirements. For proper tool
performance, the air requirements at the inlet to the BAND-IT Air Controller Module of
the IT1000 must be:
Item Min Max
Inlet Supply Pressure, PSI [kPa] 100 [690] 140 [965]
Inlet Supply Air Flow, SCFM [L/s] 1.5 [0.71]
Particle Size In Air Supply, microns 5
Air Moisture Content 20% RH
Tension Pressure Setting, PSI [kPa] 50 [345] 80 [550]
Cut-off Pressure Setting, PSI [kPa] 100 [690] 110 [760]
Air Controller Module
Cut-off Pressure
Regulator Tension
Pressure
Regulator
Inlet Air Supply
Note
– An Air Booster Unit is now available to meet air pressure requirements. Please
have tool model and serial #’s available when calling the factory for service assistance.
Contact BAND-IT-IDEX customer service, 303-320-4555.
Caution
– Do not exceed a Tension pressure of 80 PSI (550 kPa). Pressures above that
may cause premature clamp failure.