It1000-ab, Troubleshooting matrix, 20 of 38 – BAND-IT IT1000-AB 1/4 Tie-Lok Tool User Manual
Page 20: 1/4” tie-lok, Tool
Document # I17791 Rev H
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
20 of 38
IT1000-AB
1/4” Tie-Lok
®
Tool
Symptom
Probable cause
Recommended Fix
Page
Control Module air pressure
valve is in "off" position.
Rotate Control Module shut-off valve to open position.
Verify gauges, air pressure and all connections.
5
Clamp tail inside tool
Remove clamp tail, if jammed remove
maintenance/flip cover and remove clamp material.
15-17
Knife is in down position.
Remove or replace knife. Verify missing and or
damaged linkage.
23
Wrong clamp type for tool
Verify proper tool for selected clamp.
Cover page
Handle will not
adjust
Handle nut is
damaged/misaligned.
Remove handle assembly and inspect nut/housing for
damage. Replace as required.
9
Clamp will not
insert into tool
* = for additional assistance, contact BAND-IT
Troubleshooting
Matrix