Tcp client application: configure sw550x as a pair, Connection slave – Atop Technology SW550X User manual User Manual
Page 76

Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
70
4.2.6 TCP Client Application: Configure SW550X as a Pair Connection Slave
A Pair Connection Slave, is shown in Fig. 4. 14; it is necessary to pair up with a Pair
Connection Master. Please setup a Pair Connection Master first before proceeding.
Fig. 4. 14
Follow
Sec. 4.1.2
to configure SW550X in TCP Client mode properly.
Click on the dropdown box of the Application
option and switch to “Pair Connection
Slave
” to enabled Pair Connection application in SW550X.
Match the Destination IP
with the settings of Pair Connection Master’s IP that was
setup previously.
Scroll to the bottom of the page and click on “Save & Apply” button to save the
changes.