Atop Technology SW550X User manual User Manual
Page 37
Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
31
WPA2 (with RADIUS): Depending on the Authentication Mode selected, different fields
would be enabled. WPA2 (PEAP) would require you to provide the user, password, and
the certificates. WPA2 (EAP-TLS) would require you to provide the certificates and
private key password. WPA2 (EAP-TTLS) would require you to provide the user,
password, and the certificates. Please note that only *.pem certificates are supported.
Please remember that 2.4 GHz frequency is easily interfered by other devices that operate in
the same region (namely, Bluetooth, Zigbee, Microwave, etc.) so it is better to choose the
802.11a/n which operates in the 5 GHz when your network allows it.
Steps to Connect to an Access Point
Input the SSID of the connecting Access Point
or you can use the “Scan network” to have
SW550X grab the necessary wireless information of surrounding access points in the device’s
coverage area, please be patient as this process might take as long as 10 seconds.
Once it has finished scanning, names and basic properties of available networks will be shown
as in Fig. 3. 12 . After this, you can now select an AP from the list and its settings would load
automatically to the device’s UI.
Fig. 3. 12