6 factory default settings, Factory default settings – Atop Technology SW550X User manual User Manual
Page 20

Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
14
It is also worth noting that as a first step to view your device’s overall settings, you should use
Serial Manager© (the utility provided in the CD). There will be however, three buttons which
will be present during almost each section, Table 2. 2.
Table 2. 2
Button
Function
Saves and apply the current configuration input on the page.
As the caption implies, it applies the current configuration until the device
is restarted.
Cancel the current configuration input and shows the original setting.
2.6 Factory Default Settings
Upon arrival, the device will be set as follows, note that the SW550X Series comes with two
different IP address for LAN and WLAN, Table 2. 3.
Table 2. 3
Interface
Device IP
Subnet mask
Gateway IP
DNS1
LAN
10.0.50.100
255.255.0.0
10.0.0.254
168.95.1.1
WLAN
192.168.1.1
255.255.255.0
192.168.1.254
Once the device is connected to the network, you can use your browser to configure the
device. An authentication request will appear as in Fig. 2. 10.
Fig. 2. 10