AirLive WHA-5500CPE - Manual (Page 77)

5. Web Management2: System Configuration, Tools and Status
AirLive WHA-5500CPE User’s Manual 70
5.1.4 System Management
System Configuration -> System Management
In this page, administrator can change the management parameters and disable/enable
management interface.
System Administration
„ HTTP Port No: The default port for HTTP is Port 80, you can change the value here
„ Timeout: The default management timeout is 10 minutes. After timeout, the
WHA-5500CPE will ask you to login again. You can change the timeout value here.
„ HTTP Web Server Access: You can enable or disable HTTP service from WAN side
„ HTTPS Web server Access: You can enable or disable HTTPS Web Server Access
from WAN side
„ Response to WAN ping: You can disable or enable whether WHA-5500CPE will
response to PING command.
Telnet: Disable/Enable Telnet Interface.
UPnP: Click here to enable UPnP. It is recommended not to open UPnP for security
reason.
Syslog: Syslog is an IETF (Internet Engineering Task Force - the Internet standards
body)-conformant standard for logging system events (RFC-3164). When the
WHA-5500CPE encounters an error or warning condition (ie., a log-in attempt with an
invalid password), it will create a log in the system log table. To be able to remotely view
such system log events, you need to check the Enable Syslog box and configure the IP
address of a Syslog daemon. When doing so, the WHA-5500CPE will send logged
events over network to the daemon for future reviewing.