AirLive WHA-5500CPE User Manual
Page 141
11. Frequent Asked Questions
AirLive WHA-5500CPE User’s Manual
134
WEP). If using Bridge Infrastructure mode (WDS station), please enable
“WDS Dynamic” on Mikrotik’s “AP Bridge” mode. If using WEP, please
choose “Static Key Required” on the Mirkrotik setting. For step-by-step
example, please visit AirLive.com’s support page at:
Type “WHA-5500CPE” at the
support search.
====================================================================
Question
:
When I plug in the POE cable and power adapter, the WHA-5500CPE’s power
LED is not on?
Answer: Please make sure you have connected the PoE cable to the correct port on
the DC injector. Moreover, you should use an Ethernet cable with 4 twisted
pairs (CAT5 or better) for POE cable.
====================================================================
Question
:
When I use an external antenna with WHA-5500CPE?
Answer: Yes, you will need our RG-178MXFN converting cable. Please visit the link
for detail procedure:
====================================================================
Question
:
I tried the Emergency Upgrade procedure. But it doesn’t work, why?
Answer: Please make sure the firmware file is renamed to “zImage” without any file
extension. The file name has to match exactly with the big capital “I”.
====================================================================
Question
:
Where is the signal survey function that displays the RSSI value continuously?
Answer: The “Signal Survey” function is inside the Site Survey function. You can
access from “Operation Mode -> Setup -> Site Survey” menu.