AirLive WHA-5500CPE - Manual (Page 50)

4. Web Management-Wireless and WAN Settings
43 AirLive WHA-5500CPE User’s Manual
„ Enable 802.1d: Enable the Spanning Tree Protocol to prevent forming a network loop.
This option is especially important for WDS Bridge mode.
„ Enable 802.11d: Also known as “Global Roaming”. 802.11d is a standard for use in
countries where systems using other standards in the 802.11 family are not allowed to
operate.
4.2.14 Access Control (ACL)
Operation Mode -> Setup -> Access Control
The WHA-5500CPE allows you to define a list of MAC addresses that are allowed or
denied to access the wireless network. This function is available only for Access Point
and AP Router modes.
„ Disable MAC address control list: When selected, no MAC address filtering will
be performed.
„ Enable GRANT address control list: When selected, data traffic from only the
specified devices in the table will be allowed in the network.
„ Enable DENY address control list: When selected, data traffic from the devices
specified in the table will be denied/discarded by the network.