AirLive WHA-5500CPE User Manual

Page 60

4. Web Management-Wireless and WAN Settings

AirLive WHA-5500CPE User’s Manual

To configure, please click on the “Bandwidth Control” button under wireless settings. The
following screen will appear:

Enable Bandwidth: Check to enable Bandwidth Control. Uncheck to disable it.

The default value is disabled.

You must select between Total Bandwidth and Per-User Bandwidth. They can not be
enabled at the same time.

Total Bandwidth: Total Bandwidth control limit the bandwidth between Wireless and

Ethernet interface. Therefore, it is most suitable for Client Infrastructure Mode, Bridge
Mode, and WISP Router Mode. For WISP operator who use WHA-5500CPE as the
client side device; setting the Total Bandwidth control on the WHA-5500CPE will easy
the loading on the AP for bandwidth management. To begin, please enable the
Bandwidth Management first. Then enter the downlink and uplink speed; click on
Apply to finish.

Total Downlink Speed: Enter speed you wish to limit the download traffic in Kbps

units.

Total Uplink Speed: Enter the speed you wish to limit the upload traffic in Kbps

units.

Per User Bandwidth Control: Per user Bandwidth Control can limit speed of

individual PC and network device. The WHA-5500CPE allows multiple Per-User

After enabling
Bandwidth Control
and selecting
“Total” or “Per
User” type, click
here to Apply

Check to enable
Bandwidth
Control

Select Total or
Per User
control here

Settings for
Total Bandwidth
Control

Settings for
Per-User Bandwidth
Control