AirLive WHA-5500CPE - Manual (Page 17)

2. Install the WHA-5500CPE
AirLive WHA-5500CPE User’s Manual 10
2
2.
Installing the
WHA-5500CPE
This section describes the hardware features and the hardware installation procedure for
the WHA-5500CPE. For software configuration, please go to chapter 3 for more details.
2.1 Before You Start
It is important to read through this section before you install the WHA-5500CPE
„ The WHA-5500CPE comes with everything you need to start installation with
exception of the PoE Ethernet Cable. You can use a good quality CAT-5E
outdoor graded Ethernet cable (shielded with anti-UV) according to the length
you need.
„ The WHA-5500CPE must be installed in the upright position if the unit is located
in outdoor or wet environments.
„ The use of 5GHz spectrum, Turbo modes, and 5/10MHz channel bandwidth
might be prohibited in some countries. Please consult with your country’s
telecom regulation first.
„ You must set the distance parameter to make long distance connection work.
Please refer to chapter 4 of this user’s guide for details.
„ The integrated antenna has forward coverage angle of 30 degree both in vertical
and horizontal direction.
„ The WHA-5500CPE is a 5GHz CPE device only, it can not operate in 2.4GHz.
„ If you choose to use the external antenna, please remember to connect the
external antenna first before power on WHA-5500CPE.