3 wds settings – AirLive WHA-5500CPE User Manual

Page 64

4. Web Management-Wireless and WAN Settings

AirLive WHA-5500CPE User’s Manual

4.3 WDS Settings

Operation Mode -> Setup -> WDS Settings

WDS Bridge mode can make Point-to-Point and Multi-Point connections. Because of its
faster performance, it is frequently used to build point-to-point bridge connection and
backbone networks. In a WDS network, each node can have up to 4 connections.
However, the total number of devices in a WDS network should not exceed 8. Currently,
the WDS Bridge mode can only use WEP encryptions policy.

TIPS: For step-by-step instructions on how to build a WDS bridge network, please be
sure to read through Chapter 9: WDS Bridge Example for details.

In this section, we will talk about the WDS Settings which is available only in WDS Bridge
(Pure MAC) mode. WDS Bridges are using BSSID (AP’s Wireless MAC address) to
authenticate each other. Therefore, it is necessary to know the remote Bridge’s wireless
MAC addresses. You can always do a “Site Survey” to find out the MAC Addresses.

When you click on WDS settings, the following screen will appear:

WEP Key: You can set up to 4 keys, each key can have different Key Length

and Key type. When you add an entry to the WDS setting and select WEP

Here are the
encryption key
settings for WEP.
Please make sure
all bridges in the
WDS network enter
the same keys.

This is where you enter
the remote Bridge’s
information. The SSID
must be different between
each Bridge.

After you add a
remote Bridge, it
will be display
here. Up to 4
entries are
possible