Clip routing table + callback, Ethernet configuration – 2N StarGate/BlueTower v5.3 User Manual
Page 92
92
CLIP Routing Table + CallBack
Use the table to set a fixed CLIP assignment of incoming CLIPs from GSM to the
numbers of extensions to which incoming calls are routed automatically. Also, set the
CLIP list in the GSM network for which CallBack is enabled.
GSM number (CLIP) – user Id in GSM/UMTS.
Used Service
Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.
Ignore call – ignore call for the selected CLIP
Tone dial–in – incoming GSM calls is accepted + dialtone is activated for
the selected CLIP
Disa message dial–in – incoming GSM calls is accepted + voice
message is activated for the selected CLIP
Dial to VoIP – VoIP destination number for the CLIP routing function.
Auto CallBack – enable/disable CallBack routing for the selected CLIP.
Call duration limit
– set the maximum call duration (minutes).
Note
Remember to activate the CallBack mode in the GSM incoming
for a proper function.
groups
The maximum count of CLIP routing table records is 96.
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in 2N
StarGate /
®
.
BlueTower
IP address – the fixed IP address (v4) of the 2N
StarGate / BlueTower
®
Ethernet interface.
Subnet mask – the subnet mask for the
Ethernet
2N
StarGate / BlueTower
®
interface.
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
– primary DNS server.
DNS server1
– secondary DNS server. Used as a back-up when DNS server 1 is
DNS server2
not functional.
Caution
Incorrect settings, e.g. enabling the
, may
DHCP client service
result in a denial of access to the 2N
StarGate / BlueTower
®
configuration. To avoid this, restore the GSM gateway default
settings.
Refer to Subs.
for details Jumper pro
default.