2N StarGate/BlueTower v5.3 - Manual (Page 79)

79
2N TELEKOMUNIKACE a.s., www.2n.cz
®
– with this parameter activated, the Receive dial number from Subaddress
gateway uses the digits in the Subaddress field instead of the Called party
number for outgoing dialling.
– a specific feature designed for the Hungarian dial tone after 2 digits
Hungarian national dialling plan. The gateway activates a specific dialtone for
second dialling after receiving two digits.
– when the ISDN PRI is in the TE mode, the Don't send ConnectAck on TE
gateway will not send the CONNECT_ACK message.
Use CLIR if requested from ISDN (SETUP) – enable automatic CLIR
resending to GSM/UMTS if required so by the ISDN.
Tone Signalling for Calls from ISDN
Dial tone to PRI1 with empty SETUP – set the dial tone type to be generated
by the PRI gateway.
Ring tone – set the ring tone type to be generated by the PRI gateway.
Generate busy tone to PRI1 – set the busy tone type to be generated by the
PRI gateway into the PRI 1 interface.
Generate busy tone to PRI2 – set the busy tone type to be generated by the
PRI gateway into the PRI 2 interface.
set the ring tone type to be generated by the Ring tone from PRI1 to PRI2 –
PRI1 interface into the PRI 2 interface.
Numbering Plan Settings
– use these parameters to set the Numbering plan for the called CDN, CGN
(CDN) and calling (CGN) numbers.
Binary value Decimal value Description
0000 0 Unknown numbering plan
0001 1 ISDN/Telephony numbering plan
0011 3 Sata numbering plan
0100 4 Telex numbering plan
1000 8 National standard numbering plan
1001 9 Private numbering plan
1111 15 Reserved for Extension
ISDN Parameters – Monitoring
Caution
This service is file-licensed. Refer to Management–>Licence
for the current GSM gateway licence details. key
PRI1 alerts
Send SMS at state changes – enable/disable alert sending upon PRI1 state
change.