2N StarGate/BlueTower v5.3 User Manual

Page 85

Note

The SMS at no answer function works properly only if the
INVITE message contains the called and caller numbers.

Delay for ALERTING [a] – define a delay before sending information on ringing
start.
Minute parameter – select whether or not the GSM gateway should record the
call length or count for outgoing call restriction.
Day of deleting statistics in group (every month) – define a day on which
statistics on disconnected calls should be deleted.
SIM settings – select which settings will be used for the SIM cards in positions
5 – 8:

SIM 5–8 is SIM 4 – all settings for the SIM cards in positions 5 – 8 will be
the same as those for the SIM card in position 4.
SIM 5–8 is SIM 1–4 – all settings for the SIM card in position 5 will be the
same as those for the SIM card in position 1. The SIM card in position 6 will
use settings of the SIM card in position 2, SIM 3 = SIM 7 and SIM 4 = SIM
8.

Disable tone detection – Deactivate the alerting tone detectors on the GSM /
UMTS boards. Used for the GSM / UMTS networks that send call statuses through
the signalling channel.
Generate virtual ring tone – enable/disable generation of the virtual ringing
tone to the VoIP interface.
Call length counting – select whether the call should be counted in seconds or
minutes.
BTS lock – identify the BTS to which the GSM modules should be logged fixedly.
Restart the selected GSM modules to execute the changes.
After call relax delay – interval between the current call termination and next
call setup via the same GSM/UMTS module. 2 seconds is recommended for
high–traffic installations.

Disconnect Call

Set the rules for automatic disconnection of outgoing calls to a wireless network.

SIM limit exceeded – automatic call disconnection when the active SIM card
call limit is exceeded.
Time limit exceeded – automatic call disconnection when the active SIM card
time of use is exhausted.
No ALERTING before CONNECT – automatic call disconnection when the
gateway receives the call connect message without alerting.

Block SIM

Set the rules for SIM switching in the event of SIM limit exceeding.

enable/disable SIM switching when

Tariff 0(...4) minutes limit exceeded –
the tariff 0(...4) minutes limit has been exhausted.

enable/disable SIM switching when the SMS limit has

SMS limit exceeded –
been exhausted.

enable/disable SIM switching when the maximum

Minutes limit exceeded –