2N StarGate/BlueTower v5.3 User Manual
Page 157
157
SMS Control
SMS control can be activated for only one
session at a time.
AT!G=#
A6 – activate control via used session55 – deactivate
control via used session99 – deactivate control on all
sessions
AT^MS=ch
Module status ch=0 – 31
*module:
ch,sim,sts3,sts2,phs2,type
Response to AT^MS:ch – number of wireless
enginesim – number of currently used SIM: 0-none,
1-8-holder 1-8sts3 – status of layer 3sts2 – status of
layer 2phs2 – substatus of layer 2type – type of
wireless engine
AT^MI=ch
Module info ch = 0 -31
*minfo:
ch,sim,netid,"oper",new,cnt
Response to AT^MInetid – network ID of active
wireless networkoper – name of active wireless
networknew – number of received and saved SMS on
SIM cardcnt – total number of sent SMS messages
according to statistics
*smsinc: ch,ix,sts,mem
SMS message has been received and savedix –
index number of saved SMS (0-250)sts – status of
SMS (from +CMGL: ix.sts.len)mem – type of used
storage (1,2,3)
*smsrep: ch,ix,sts,mem
SMS status confirmation has been receivedsts –
reserved (0)
*smsout: ch[/id],ref,req
SMS message was sent and not saved to SIM
cardRef – reference number of SMS (0-255) – to be
used in status confirmation messagesID – third party
identification number of SMS
*smspdu:
ch,ix,sts,len,pdu,csum
Content of SMS messagelen – length of SMS
message (number of bytes in PDU)PDU – content of
message in PDU formatcsum – checksum of all PDU
bytes (2 hexa digits) calculated without carry
*smsdel: ch,ix
SMS message deletion confirmation
*smserr:
ch[/id],ix,req,err,cms
Fault command response, or SMS not sentreq –
required wireless engine or GSM grouperr – error
code (6-busy,40-write,41-read,42-delete,43-list)cms
– error cause from wireless engine
*smssel: ch,cnt
SMS storage change confirmation