2N StarGate/BlueTower v5.3 - Manual (Page 60)

60
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.1 Important Default Settings
The following table shows the default values of important parameters:
Parameter Value
IP address of basic CPU 192.168.1.2
IP mask of basic CPU 255.255.255.0
IP address of gateway 192.168.1.1
IP address of VoIP board 0.0.0.0
IP mask of VoIP board Same as basic CPU configuration
IP address of enhanced CPU By DHCP server
IP mask of CPU enhanced By DHCP server
Username / Password of basic CPU Admin / 2n
Username / Password of enhanced CPU Admin / 2n
Username / Password of ERM Admin / 2n
Transmission rate RS232 of CPU 57600bps
Transmission rate RS232 of eCPU 115200bps
Caution
To prevent unauthorised access please change the default
access username and password as soon as possible!
For default reset, use the JP1 jumper for the CPU and JP2 jumper for the eCPU.
CPU Factory Reset
Follow the instructions below to set the default values for the CPU:
Switch off the GSM gateway.
Remove the CPU card and connect JP1 to the DEF position.
Insert the CPU card and switch on the GSM gateway.
Wait for one minute and switch off the GSM gateway again.
Remove the CPU card and reconnect JP1 to the CPU/eCPU position.
Insert the CPU card and switch on the GSM gateway.
Now the factory settings are restored on the CPU.