2N StarGate/BlueTower v5.3 - Manual (Page 80)

80
2N TELEKOMUNIKACE a.s., www.2n.cz
®
PRI2 alerts
Send SMS at state changes – enable/disable alert sending upon PRI2 state
change.
PRI common settings
– Timeout for ISDN line deactivation detection [s] an SMS alert on
PRI1/PRI2 deactivation is sent after this timemout.
– an SMS alert on PRI1/PRI2 Timeout for ISDN line activation detection [s]
activation is sent after this timemout.
Numbers where SMS will be sent to
– list of numbers to which the SMS alert
shall be sent.
Text of SMS
– SMS alert text with the following parameters:
%P(x|y), where "x" represents any text concerning PRI1 and "y" represents
any text concerning PRI2.
%A(x|y), where "x" represents any text for interface deactivation and "y"
represents any text for interface activation.
Settings of Alive SMS interval
Send Alive SMS – enable/disable sending of ALIVE SMS.
– ALIVE SMS sending time. Time [hh:mm]
– ALIVE SMS sending interval. Days interval
Numbers where SMS will be sent to – list of numbers to which the ALIVE SMS
shall be sent.
– ALIVE SMS text. Text of SMS
Port Modes
This item helps you set each of your gateway ports. The settings are based on the LCR
table including relevant routing/rejecting rules for all incoming and outgoing calls.
GSM Basic Parameters
Digits Dialled from VoIP
Minimum numbers from VoIP – set the minimum count of digits to be dialled
into the GSM network.
Maximum numbers from VoIP – set the maximum count of digits to be dialled
into the GSM network.
Wait for next digit [s] – set the timeout for 2N StarGate / BlueTower
®
gateway to wait for the next digit dialled from VoIP to GSM.